Electromagnetic ballasts

Electromagnetic (inductive) ballasts are active components that in conjunction with starters preheat the lamp electrodes, supply the ignition voltage and stabilise lamp currents during operation. Series or parallel capacitors are required to compensate blind current.
For installation in luminaires, consideration must be taken of the mains voltage and mains frequency, the dimensions and maximum thermal values as well as any potential noise generation. To fulfil these special requirements, Vossloh-Schwabe provides numerous ballasts with differing technical specifications.
Vossloh-Schwabe magnetic ballasts have been optimised with regard to their magnetic fields and loads so that they are usually unnoticeable. However, as magnetic vibrations can affect large areas depending on the luminaire design, this should be taken into consideration when designing luminaires. If necessary, beads or grooves should be fitted to prevent vibrations from spreading. The service life of an inductive ballast is determined by the material chosen for the winding insulation. The maximum winding temperature denotes the temperature (tw) that the insulation will withstand for a period of 10 years given continuous operation under rated conditions. This maximum winding temperature must not be exceeded in real conditions to ensure the ballast can achieve its full service life. The winding temperature of the ballast that is measured in the luminaire is made up of the ambient temperature of the luminaire, the thermal conditions within the luminaire and the power loss of the ballast. The Dt marking on the ballast type plate provides a measure of the power loss of the ballast. In addition to this, the power loss of ballast-lamp circuits is measured in accordance with EN 50294. This test method forms the basis for the CELMA energy classification of ballasts and is also applied in European Directive 2000/55/EC "Maximum Values Regulation of the Power Input of Fluorescent Lamp Circuits".

As a result of their design features, inductive ballasts cause leak current that is discharged via the earth conductor (potential connection) of the luminaire. The maximum permissible leak current for protection class luminaires is 1mA, a value of which all Vossloh-Schwabe electronic ballasts fall clearly short. Values of max. 0.1 mA are measured per electromagnetic ballast. However, as these values accumulate with the number of installed ballasts, this should be taken into account when dimensioning the F1 protective switch.
Starters for fluorescent lamps
As mentioned above, the operation of fluorescent lamps also requires starters in addition to ballasts. A distinction is made between glow starters, which are also available with automatic cut-outs, and electronic starters. The correct choice of voltage and power range is crucial. Starters are available for 220 - 240 V and for 110 -127 V mains voltage. The latter are also required for twin-lamp operation (e.g. 2x18 W at 230 V). Operating the VS ballast SL (100 -127 V) depends on the use of a 220 - 240 V starter as these operating devices are high-reactance transformers that supply higher voltages to the lamp.